Programming Cards and Tags
CP-R25 Hardware & Software Manual
Page 25
Serial number user cards as well as Reader configuration
cards.
•
Swipe reader – Used to write and read cards containing
fingerprint templates. This tab also allows the creation of
configuration cards for fingerprint readers.
The AS-B01 application offers various configuration options
including the following:
•
Configuring the Card ID, card key and fingerprint
enrollment separately. This is for a new MIFARE User Card.
•
Configuring the Card ID and card key at the same time.
This is for a previously configured MIFARE User Card.
•
Configuring the Card ID, card key and fingerprint
enrollment at the same time. This is for a previously
configured MIFARE User Card.
Once the card is configured, the Card ID and the KeyA value
can be modified, of if required, completely wiped from the
card.
There is also an option to configure the Card ID, KeyA
programmer key as well as do the fingerprint enrollment on a
previously configured MIFARE User Card in one operation.
5.5
Programming a Sector Read User Card
The first stage of preparing a MIFARE sector read User Card is
configuring a card ID and card KeyA value. These two
configuration values are done simultaneously.
To Program a MIFARE Sector Read User Card:
1. Select
Sector Reader
tab.
2. Select
the
Sector
Operation Mode
.
Define the
ID Location
using the
Sector Number
,
Block
Number
, and
Byte Number
fields.
Note:
If Card serial number is being used by the organization, no
programming is available for the user card.
3. Ensure that the
Operations
is set to
Program Card
.
