Fingerprint Enrollment
AYC-B7661 Installation Manual
23
3.
Present the Delete card.
If valid, the unit emits three short beeps and the LEDs blink green.
The users do not need to place their finger on the unit’s sensor.
If an error occurs, the unit emits an error tone and the LEDs turn
red for about one second.
5.2
Enrollment in 1:1 Mode
In 1:1 mode, the unit identifies users according to their fingerprints
and their user MIFARE smart cards.
Before enrolling users, it is recommended to create a list of all users
and their record number (see Appendix
A
). The unit accepts up to 107
users.
To enroll cards and fingerprints:
1.
For first time use, configure the reader as explained in Chapter
4
.
2.
When the reader is in standby mode, present the Enroll card to
the unit.
Both LEDs flash orange.
3.
Present the record number (+10 and +1) cards the number of
times required to reach the desired record number.
Each time a card is presented the reader emits one beep.
For example, to enroll a fingerprint to record number 32
present the +10 card three times followed by the +1 card twice.
4.
Present the Enroll card, and then present the user’s card.
The right LED flashes green and the left LED turns off. The unit
emits a long beep.
5.
Ask users to place their finger on the unit’s sensor once for first
identification.
When it successfully identifies the fingerprint, the unit emits one
short beep.
6.
Ask users to place their finger on the unit’s sensor once more.