Maintenance
Page 44
RESM-5
10.1
Customer settings
The unit's factory settings can be defined or restored
with step 202 in the Configuration menu. You can store
customer settings in addition to the Ropex settings:
The following settings are possible:
1.
"Restore Ropex settings"
(factory setting)
By choosing this option, you restore the values
listed in section 10 "Factory settings" on page 43.
These values correspond to the factory settings with
which the unit was shipped.
2.
"Define customer settings"
By choosing this option, you save the values that
are currently defined in the unit's Settings and
Configuration menus as "customer settings". These
"customer settings" are independent of the Ropex
settings. Machine-specific settings can be stored in
the unit in this way.
3.
"Restore customer settings"
By choosing this option, you restore the "customer
settings" that were defined as described in 2.
When the unit is shipped, the "customer
settings" are identical to the Ropex settings.
After pressing the "ENTER" key in this menu, you are
asked to confirm the new settings (safety query).
If you confirm these settings by pressing the "ENTER"
key for approximately 2seconds, you then see another
message.
You can also cancel the new settings by pressing the
"MENU", cursor "UP", or cursor "DOWN" keys.
Step 203 then appears on the display.
The language selected with step 201 in the
Configuration menu remains set if the
previous settings are restored.
11
Maintenance
The unit requires no special maintenance. Regular
inspection and / or tightening of the terminals is
recommended. Dust deposits on the unit can be
removed with dry compressed air.
To prevent dangerous situations, refer to the
risk analysis for the machine or plant (e.g.
carry out regular functional tests).
!
!
!