Tighten the screws on the top of the unit to secure the items into the unit.
Connect the Power Supply Unit. If the fit does not seem tight, ‘wiggle’ the lead into
the light source, whilst pushing at the same time.
Using the ON/OFF rocker switch at the back of the light source, switch the light
source on.
14.
Care and Maintenance
Store out of reach of clients – do not allow unsupervised use.
This 2-Port Light Source contains LEDs which typically last thousands of
hours. Therefore it will not be necessary to change any bulbs.
If removing your Fibre Optics etc., first unscrew the screw that secures these in
place, do not just pull them out. This will cause damage to the unit.
15.
Troubleshooting
In the unlikely event of product failure, please check the following:
Problem: No light
Check that the Power Supply Unit connecting lead is pushed firmly into the light
source
Check the fuse that is in the Mains Power connector fitted to the back of the light
source.
Check the fuse in the plug (if UK plug fitted). This should be a 5A standard mains
fuse.
Remove any connection to the round black 5 pin socket on the back of the light
source.
Turn the light source OFF, wait 1 minute and then turn ON again.
Problem: Insufficient Brightness from the Light Source
Slide boss into
the holes
Boss
Boss
Screws (these are the ones that
need tightening or loosening when
changing/removing the bosses.)
