11.
Safety
Always supervise the use of this product
Only use the Power Supply Unit supplied with this light source. Do not connect any
other power supply as this may damage the product.
Use indoors, in dry environments.
This product is not a toy.
Remove all packaging and either store this in a safe place out of reach of clients or
dispose of this responsibly. Plastic bags and wrapping can be hazardous to children
and vulnerable people.
Keep away from sources of heat and fire.
Install the light source out of reach of clients.
Allow unrestricted airflow around the light source. The ambient temperature should
not exceed 40ºC.
Do not allow clients to pull on the Fibre Optics.
Should you need to remove the Fibre Optics, remove the boss with care – release
the screw – do not just pull these out with force.
The light from the LEDs is very bright – do not look directly into the LEDs.
Refer to and follow the safety instructions provided for your Fibre Optic harness.
12.
Technical Specification
Weight (Including Power Supply Unit) 894g
Size of Lightsource (Not including Power Supply Unit) 177 x 84 x 60mm
Electrical spec (Power supply):
Input: 100-240Vac 50-60Hz 1.5A
Output: 12Vdc 5A
Approvals: CE, UL, CUL
13.
Installation
Remove all packaging from the 2-Port Light Source.
Check product to ensure that it hasn’t been damaged in transit. In the unlikely event
that any problems are found, contact ROMPA® immediately
Decide where to locate the 2-Port Light Source.
Consider plug access. Check length of cable and ensure that where you choose to
locate the 2-Port Light Source will not put strain on the cable, product, Power Supply
Unit or plug.
If using a shelf or bracket check these can comfortably hold the weight of the unit.
The 2-Port Light Source has four predrilled holes to two sides to enable this to be
secured down to a wall or other surface if this is required.
Slide the bosses of your fibre optics, Starcloth or Milky Way Carpet into the circular
holes in the front face of the light source.
