33
Switching the grilling areas on
• Choose the grilling area on which you would like to grill.
• By pressing the “+” button, the grilling area starts with temperature
level “6”.
• By pressing the “-” button, the grilling area starts with temperature
level “10”.
• By pressing the “+” or “-“ button, the temperature can be increased or
decreased stepwise any time.
• By permanently pressing the “+” or “-“ button, the temperature levels
can be changed quickly.
• At the first heating-up, the LED pilot lamps blink until the set temperature is reached, afterwards the
LED pilot lamps glow permanently.
• First, heat the appliance up at the desired level until the LED pilot lamps glow permanently before
starting to grill.
During grilling
• During grilling, make sure that the fat outlet does not get chocked, clean it occasionally if necessary.
• By pressing the “+” or “-“ button, the temperature can be increased or decreased stepwise. By
permanently pressing the “+” or “-“ button, the temperature levels can be changed quickly.
Switching the grilling areas off
• Press the “-“ button until level “0” is reached (all LED of the tem-
perature indication are off).
or
• Press the “+” and the “-“ button at the same time for at least 1 sec-
ond and level “0“ is immediately selected (all LED of the temperature
indication are off).
• Switch the second grilling area off as described above.
or
• By pressing the “ON/OFF” button for at least 1 second, both grilling
areas are switched off at the same time.
• If no grilling area is active any more, the electronics switches to the
stand-by mode after 5 seconds.
NOTE:
Activating a grilling area is indicated by an audible signal!
NOTE:
At a later reheating, the LED pilot lamps do not blink!
NOTE:
The LED pilot lamps blink again if the temperature level is increased and the appliances heats up.
If the newly set temperature is reached, the LED pilot lamps glow permanently again!
NOTE:
When the temperature inside the control unit rises over a set level, the integrated fan switches
on. As soon as the temperature falls below the set value, the fan goes out again. This process may
repeat several times!
