24
5.2.3 –
replace Brita filter
( displayed until Brita filter is replaced )
Depending on machine’s configuration, this message may be displayed after a preset value of
water volume used by the machine.
5.3 – lEVEl 3 ( contact tHE maIntEnancE DEPartmEnt )
5.3.1 – breWing unit error
No intensity detected on the brewing unit. Brewing Unit must be replaced.
5.3.2 – WAter FloW rAte probleM
Defective Pump or blocked brewing unit. Pump or brewing unit must be replaced.
5.3.3 – heAting
If “Heating” remains displayed for more than 2 minutes, it may come from a heater problem ( it
must be replaced ).
5.4 – trouble shot – pod jAMMing
In case of pod jamming, machine must be turned OFF, and unplugged. Then, user must open Top
Cover N°1, and with care, extract the jammed pod. Once this is done, close Top Cover N°1, switch
machine ON again, and wait till “Select your drink” message is displayed. Do not use previously
jammed pod, please throw it directly to bin.
6 – Machine prograMMing – voluMes
to enter Prog mode, press the service button for 5 seconds when the machine indicates
“select your drink”.
In Prog mode machine displays “Password”: Enter the code 0000.
see the control pad to scroll, validate selection and record the values.
6.1 – coffEE VolumE sEttIng
6.1.1 – Expresso volume ( Factory setting 40ml )
Select ESPRESSO and validate the selection
Select the volume ( between 30 to 180ml setting is possible ) and validate the selection.
Exit setting menu.
6.1.2 – Coffee volume ( Factory setting 60ml )
Select COFFEE and validate the selection.
Select the volume ( between 30 to 180ml setting is possible ) and validate the selection.
Exit setting menu. –
6.1.3 – Long coffee volume ( Factory setting 120ml )
Select LONG COFFEE and validate the selection.
Select the volume ( between 30 to 180ml setting is possible ) and validate the selection.
Exit setting menu.
6.2 – Hot WatEr VolumE ( factory sEttIng 140ml )
Select HOT WATER and validate the selection.
Select the volume ( between 30 to 180ml setting is possible ) and validate the selection.
Exit setting menu.
7 – Machine prograMMing – advanced settings
to enter Prog mode, press the service button for 5 seconds when the machine indicates “select your
drink”.
In Prog mode machine displays “Password” : Enter the code 1234.
see the control pad to scroll, validate selection and record the values.
Here below, functions will be displayed in addition of Volume settings described in chapter 6.
7.1 – language choice
To set machine’s language, use the control pad to scroll, validate selection and record the
language.
7.2 – Brightness
To set machine’s display brightness, use the control pad to scroll, validate selection and record the
desired value.
