TAPMATE
™
XL 424 OPERATING MANUAL
14
1. Remove Front and Rear Braces from Work‑
station.
2. With the Large Adapter Hub properly in‑
stalled on the Lead Tube (see steps on page
8‑9), lift and move the appropriate size and
style TapMate XL‑424 Adapter Bell into place
(see fig. 22)
.
3. Remove the six Nuts and Washers from the
outside of the Adapter. Also make sure that
the Adapter Bell Gasket is in place.
4. Lift the Adapter Bell by the Lifting Eye, and
move it into place. The Shaft goes through
the Center Hole in the Adapter. Carefully
slide the Adapter Bolts through the Mating
Holes in the Large Adapter Hub.
5. Replace the Nuts and Washer back onto the
Adapter and tighten Nuts in a star pattern.
6. Remove the Brake Tube Locking Bolt from the
Brake Tube
(see fig. 23)
. This will allow the
Brake Tube to rotate.
TAPMATE XL-424 SET-UP FOR 14"-24" TAPS
For instructions on attaching the Small Adapter Bell (for 4"-12" taps), go to page 8.
fig. 21
fig. 22
fig. 23
