66
Flash light transmitter mode
Flash bracketing (FEB)
By using FEB the flash exposure will be automatically changed, which helps in
conditions of invariable background exposure . You can take three flash shots while
automatically changing the flash output according to 1/3 to plus or minus . After the
FEB is done, the flash will go back to the standard settings that have been used
before . (This can be turned off in the custom settings) . For using FEB set your
camera into the mode ”single shot“ and ensure that the flash is ready . Connect the
Canon camera and set on the flash exposure value surrounded exposure . If a Nikon
camera is connected to the flash exposure information will not be shown on the
flash . You need to refer to the camera settings .
FEB Setting surrounded by exposure value
(effective for Canon cameras only)
Normal firing in TTL mode
Press the up key until the icon< > is shown on
the display to enable FEB function .
Press the down key until the icon< > is not shown
on the display anymore to disable FEB function .
Increase or decrease the value
1 . Press the up key to increase the value, the more often you press the up key the
higher is the value . Press the down key to decrease the value again .
2 . The exposure range can be set from 0 to 3 .0 .
Icon
The exposure value range is as follows:
0
0.3
0.7
1.0
1.3
1.7
2.0
2.3
2.7
3.0
ENGLISH
