Roland V-Accordion FR-1x, Owner'S Manual

Page: 38 / 80

Saving your settings (User Program)
38
r
FR-1x V-Accordion
2.
Press the treble register ([1]~[4]) that is
assigned to the User Program memory
where you want to save your settings.
Each treble register provides access to two User Pro-
gram memories (for a total of eight). To select the “A”
memory, press the register in question once. Press it
twice to select the “B” memory.
The “––” to the right of “U” changes to the number of
the selected User Program.
3.
Press the [SET] register to save your settings
in the User Program memory you selected in
step 2 above.
4.
Press the [USER PROGRAM] button again to
leave this mode.
The USER PRG indicator below the display goes dark
to indicate that the FR-1x is no longer in User Pro-
gram mode. At this point, the FR-1x returns to the
settings you were using before selecting User Pro-
gram mode, and the display once again shows the
main page.
Recalling a User Program
Proceed as follows to recall a User Program you saved
earlier:
1.
Press the [USER PROGRAM] button.
The display now shows a “U––” message.
The USER PRG indicator below the display lights to
indicate that the FR-1x is now in User Program mode.
2.
Press the treble register ([1]~[4]) that is
assigned to the User Program whose set-
tings you want to use.
Each treble register provides access to two User Pro-
gram memories (for a total of eight). To select the “A”
memory, press the register in question once. Press it
twice to select the “B” memory.
The “––” to the right of “U” changes to the number of
the selected User Program.
3.
Start playing with the new settings.
If necessary, you can select a different User Program
(see step 2 above).
4.
Press the [USER PROGRAM] button again to
leave this mode.
The USER PRG indicator below the display goes dark
to indicate that the FR-1x is no longer in User Pro-
gram mode. At this point, the FR-1x returns to the
settings you were using before selecting User Pro-
gram mode, and the display once again shows the
main page.
NOTE
While the USER PRG indicator below the display lights, it is
impossible to select Sets. In order to select a Set, you will
have to press the [USER PROGRAM] button to leave User
Program mode.
Editing a User Program
You can also edit existing User Programs.
1.
Recall the User Program you want to edit.
See “Recalling a User Program”.
2.
Press and hold the [USER PROGRAM] button
to select User Program Edit mode.
The USER PRG indicator flashes. The display shows
the main page where the numbers of the selected
registers are displayed.
3.
Change the settings you want to correct.
4.
Press and hold the [USER PROGRAM] button
to enter write mode.
U--
Lights
FR-1x GB.book Page 38 Tuesday, November 8, 2011 11:44 AM