10
10
2.4 Loading a Sheet
Caution
The PNC-1050 is a sprocket type cutting machine designed exclusively for use with roll
sheets. Be sure to use only sprocket types sheets.
Sheets which can be loaded using a shaft are those with a diameter of 95 mm( 3-11/16" ) and
length up to 10 yards. For sheets of larger size, use the sheet base included with the unit.
The following explanation describes usage with the shaft.
Pass the shaft through the roll sheet and install
as shown in the figure.
When loading a sheet, keep the rear sheet guide
raised.
Pull out the amount of sheet that is to be used.
Lift up the front sheet guide pass the end of the
sheet through, and pull out as shown in of the
figure.
1
2
Engage the holes along the edges of the sheet
with the pins on the pinwheels. When doing
this, be sure that the pins are centered in the
holes.
The right-hand pinwheel is permanently secured
in place, but the left-hand pinwheel can be manu-
ally moved approx. 8 mm ( 5/16") from side to
side. Adjust this when the holes in the sheet do
not engage properly with the pinwheel.
3
4
* The pinwheel may be easier to move if grasped
from the rear the unit.
8mm
( 5/16")
Front sheet
guide
Sheet
When using a sheet base, be
sure to place it horizontally
parallel to the unit.
Correct
Incorrect
Pin
Hole in sheet
Sheet
Summary of Contents for Sign Maker CAMM-1 PNC-1050
Page 1: ...ROLAND DG CORPORATION Model PNC 1050 User s Manual SIGN MAKER...
Page 41: ...39...
Page 42: ...F2082693BE V3 1...
