12
12
2.6 Peforming Demo Cutting
Caution
Never attempt to raise or lower the rear sheet guide while cutting is in progress.
The PNC-1050 is equipped with a “demo cutting” function to conveniently allow you to check whether or not
it is capable of operating normally. Should you ever suspect that the PNC-1050 is not performing satisfactorily,
you should follow the steps below to perform the demo cutting.
* A computer is not required in order to carry out the demo-cutting.
1. Install the blade ( see “ 2.5 Installing the Blade “).
2. Set the pen force to the smallest possible value (the pen force knob should be at the furthest point to the left).
If after the first test you feel that the sheet was not cutout clean enough, you can try gradually increasing the
pen force knob until you have the optimum level.)
3. Hold down the
key on the panel while you turn the power ON. You will then see the display below.
4. Load a sheet ( see “ 2.4 Loading a Sheet “ ). Once the front sheet guide has been lowered, you will see the
display at right.
5. Press the
ENTER
key.
After the unit has scanned and calculated the media’s size, it will begin working on the Demo Cutting.
The shape shown below is cut.
0
PEN FORCE
DEMO CUTTING MODE
Check Sheet
then Press ENTER
+
Power
I
0
ON
Summary of Contents for Sign Maker CAMM-1 PNC-1050
Page 1: ...ROLAND DG CORPORATION Model PNC 1050 User s Manual SIGN MAKER...
Page 41: ...39...
Page 42: ...F2082693BE V3 1...
