Roland monoFab SRM-20, User Manual

Page: 144 / 152

144
Massage is Displayed
Message Responding Page
No modeling machine was found .
If the power is off, then switch it on .
If the cable is unconnected, then connect it .
Check connection of a USB cable .
After you take actions such as turning on the power and
connecting the cable, press
[Retry]
.
"
“Start VPanel”
(p . 11)
"
“VPanel Does Not Recognize
the Machine”
(p . 126)
The modeling machine is not responding .
Make sure that the connection cable is connected securely and the
machine is switched on . Check connection of a USB cable .
After you take actions such as turning on the power and
connecting the cable, press
[Retry]
.
"
“Operations Are Ignored”
(p . 127)
The SRM-20 has performed an emergency stop .
- X-Limit switch not found .
- Y-Limit switch not found .
- Z-Limit switch not found .
- The NVRAM could not be accessed .
Switch the machine
’
s power off, then back on again .
If the symptom persists, a malfunction may have occurred .
Switch off the machine's power and contact your authorized
Roland DG Corporation dealer where you purchase the
machine .
The SRM-20 is paused .
- Cover opened during operation .
Operation cannot be continued .
In order to resume cutting, please close a front cover and
click
[RESUME]
.
Click [STOP] , when you stop cutting .
"
“Pausing / Resuming”
(p . 104)
"
“Cancel the Cutting” (p . 105)
The SRM-20 is paused .
- Command Error
You can ignore this and continue with cutting, but doing
so is very likely to result in unintended operation, so we
strongly recommend you stop cutting .
If command does not match the machine's command set,
select correct command set .
"
“STEP 3 : Confirm the Command
Set”
(p . 83)
"
“Cancel the Cutting”
(p . 105)
Responding to Error Messages