Roland monoFab SRM-20, User Manual

Page: 128 / 152

What to Do If . . .
128
The Spindle Doesn't Rotate / Spindle Rotation Speed Is Wrong
Is a Front Cover Open?
When starting the machine, close the front cover . For safety, initialization is
not performed when a cover remains open at startup .
Is a Front Guard Pull Down ?
When the front guard falls down, the front cover can not be closed firmly .
Therefore the machine is not performed .
"
“Part Names and Functions”
(p . 9)
Is a Large Amount of Cutting Waste Present?
Clean away any cutting waste . Clean the area around the spindle head
especially carefully .
"
“Cleaning after Cutting Operation Ends”
(p . 119)
Is It the Replacement Time of a Spindle Motor?
Spindle motor is consumable . If it is used for 500 hours or more, replace for
a new spindle motor .
"
“Replacement of the Consumable Parts” (p . 122)
Is It the Replacement Time of a Spindle Unit?
Spindle unit is consumable . If it is used for 1000 hours or more, replace for a
new spindle unit .
"
“Replacement of the Consumable Parts” (p . 122)
Even if it replaces spindle motor/unit, when not being repaired
Contact your authorized Roland DG Corporation dealer where you purchase
the machine .
Has the Spindle Speed been Adjusted (Override )?
An adjusting rotation of spindle changes the rotation speed .
Unless you have a special reason for changing them, leave all overrides set
at "High.”
The Feed Rate is Wrong
Has the Feed Rate been Adjusted (Override ) ?
An override changes the feed rate . Check the settings for adjustment value .
Unless you have a special reason for changing them, leave override set at
100% .
"
“Adjusting the Feed Rate and Spindle Speed During Cutting”
(p .
106)