Roland MODELA Pro II ZCL-540, User Manual

Page: 68 / 80

66 Chapter 7 Appendix
7-1 Daily Care
Cleaning
WARNING
Never use a pneumatic blower.
This machine is not compatible with a pneumatic blower. Cutting waste may get inside the machine
and cause fire or electrical shock.
WARNING
Never use a solvent such as gasoline, alcohol, or thinner to perform cleaning.
Doing so may cause fire.
WARNING
Disconnect the power cord before performing cleaning or maintenance.
Attempting such operations while the machine is connected to a power source may result in injury
or electrical shock.
WARNING
When using a vacuum cleaner to take up cutting waste, exercise caution to prevent
fire or dust explosion.
Taking up fine cuttings using an ordinary vacuum cleaner may cause danger of fire or explosion.
Check with the manufacturer of the vacuum cleaner. When the safety of use cannot be determined,
clean using a brush or the like, without using the vacuum cleaner.
CAUTION
Caution: high temperatures.
The cutting tool and spindle motor become hot. Exercise caution to avoid fire or burns.

Carefull
y clean away cutting waste. Operating the machine with a large amount of cutting waste present may cause
malfunction.

Never atte
mpt to lubricate.
Replacing the Center Drill
The center drill is fitted with a bit
at each end. When the one in use
becomes worn, reverse the orienta-
tion and reinstall. When both ends
become worn, then replace.
Tighten
Loosen