Roland MODELA Pro II ZCL-540, User Manual

Page: 30 / 80

2-2 Step 1: Install the Unit
28 Chapter 2 Installation
For a T-slot Table
The installation method differs depending on the type of table attached. If you're using a modeling machine equipped with
a T-slot table, then use this method to install.
Procedure

Prepare the modeling machine.
Remove any tools.
Use manual feed to move the table
toward the front.
Shut down the modeling machine
and disconnect the power cable.
WARNING: Be sure to disconnect
the power cable. Failure to do so
may result in danger of injury.

Gently turn the workpiece chuck by hand until the installation hole can be seen.
Slide the T-slot nut into the groove.
Attach the drive unit.

Slide the T-slot nut into the groove.
Attach the tailstock.
Stopper
Butt this flush against
the edge of the table.
Cap screw
(M8 x 20
mm)
T-slot nut
Tab
Butt this flush at the front.
Cap screw
(M8 x 20 mm)
T-slot nut