Roland MODELA Pro II ZCL-540, User Manual

Page: 65 / 80

63 Chapter 6 Handy Panel
This displays the location of the A axis. Degrees are
used as the unit of measurement.
6-2 Moving the A Axis
Hand-wheel Feed
You can rotate the A axis using the hand wheel. This operation is basically the same as for the X, Y, and Z axes.
For related items,

p. 32, "3-1 Moving the A Axis."
WARNING
This procedure makes the machine operate. Before you perform this procedure,
check to make sure that operation of the machine will not create any hazard or
danger.
Displaying the A-axis Location
The screen displays the location of the A axis in the same way as for the X, Y, and Z axes. Degrees are used as the unit of
measurement, and this cannot be changed. Selecting the coordinate system is also the same as for the X, Y, and Z axes.
For related items,

p. 33, "About the A-axis Coordinate."
USER(RML1)
>
X
Y
Z
A
RATE x10
0.000
0.000
0.000
0.000
*READY
S 0
[ ]
100%-XYZ
100%-S
USER(RML1)
>
X
Y
Z
A
RATE x10
0.000
0.000
0.000
0.000
*READY
S 0
[ ]
100%-XYZ
100%-S
This indicates the number of steps of movement for
each click of the hand wheel. Lower scaling factors
produce correspondingly slower movement, en-
abling you to accomplish precise positioning. On the
A axis, one step is 0.01 degrees. For instance, when
this is [x100], moving the hand wheel one click pro-
duces 1 degree of movement. Note that when you're
in the RML-1 mode, [x1] cannot be selected.
The axis indicated by the symbol moves.
Pressing this button enables movem ent of the A
axis.
Each press of this changes the scaling factor for the
number of steps of movement.
When an axis has been selected, turning this moves
the axis.