Roland HP107e, Owner'S Manual

Page: 11 / 249

Before You Start Playing
9
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
Before You Start Playing
Connecting the Pedal Cable
Insert the pedal cable into the Pedal connector on
the rear panel of the HP107e.
Connecting the Speaker
Cable
As shown in the diagram, connect the speaker
cable leading from the speaker box of the stand to
the speaker connector located on the rear bottom
of the HP107e.
Push the speaker cable in until it clicks into position.
Connect the Power Cord
1.
Insert the included power cord into the AC inlet
on the bottom panel of the HP107e.
2.
Plug the power cord into a power outlet.
Setting Up the Music Rest
1.
Grasping the music rest with both hands, lift it
toward you until its in the upright position.
2.
Use the support on the back of the music rest to
keep the stand in place.
The angle of the music rest can be set to any of three posi-
tions.
■
Folding down the music rest
Raise the support located on the back of the music
rest, then gently fold down the music rest.
■
Using the music holders
You can use the holders to hold pages in place. When not
using the holders, leave them folded down.
Do not put anything that contains water (e.g., flower
vases) on this unit. Also, avoid the use of insecticides,
perfumes, alcohol, nail polish, spray cans, etc., near the
unit.
The speakers of this piano are mounted beneath the upper
surface, and face upwards. Malfunctions or accidents
may occur if liquids contact any part of the speakers.
Clip portion
Speaker connector
Speaker cable
NOTE
Speakers
Use only the attached power-supply cord.
NOTE
1
2
HP107_e.book Page 9 Tuesday, October 19, 2004 10:41 PM