Roland Fantom-X6, Owner'S Manual

Page: 286 / 348

286
Effects List
54: LONG TIME CTRL DELAY
A delay in which the delay time can be varied smoothly, and
allowing an extended delay to be produced.
fig.MFX-54
55: TAPE ECHO
A virtual tape echo that produces a realistic tape delay sound. This
simulates the tape echo section of a Roland RE-201 Space Echo.
fig.MFX-55
56: LOFI NOISE
In addition to a lo-fi effect, this adds various types of noise such as
white noise and disc noise.
fig.MFX-56
Parameter Value Description
Delay Time # 0–2600 ms,
note Adjusts the time until the delay is heard.
Acceleration 0–15 Adjusts the time over which the Delay
Time changes from the current setting to
a specified new setting.
The rate of change for the Delay Time
directly affects the rate of pitch
change.
Feedback # -98– +98 % Adjusts the amount of the delay that’s
fed back into the effect. Negative (-) set-
tings invert the phase.
HF Damp 200–8000 Hz,
BYPASS Adjusts the frequency above which
sound fed back to the effect is filtered
out. If you do not want to filter out any
high frequencies, set this parameter to
BYPASS.
Pan # L64–63R Stereo location of the delay
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Balance # D100:0W–
D0:100W Volume balance between the direct
sound (D) and the delay sound (W)
Level 0–127 Output level
Parameter Value Description
Mode S, M, L,
S+M, S+L,
M+L,
S+M+L Combination of playback heads to use
Select from three different heads with
different delay times.
S: short M: middle L: long
Repeat Rate # 0–127 Tape speed
Increasing this value will shorten the
spacing of the delayed sounds.
Intensity # 0–127 Amount of delay repeats
Bass -15– +15 dB Boost/cut for the lower range of the echo
sound
Treble -15– +15 dB Boost/cut for the upper range of the echo
sound
Head S Pan L64–63R Independent panning for the short, mid-
dle, and long playback heads
Head M Pan
Head L Pan
Tape Distor-
tion
0–5 Amount of tape-dependent distortion to
be added
This simulates the slight tonal changes
that can be detected by signal-analysis
equipment. Increasing this value will
increase the distortion.
L in
R in
L out
R out
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
2-Band
EQ
Feedback
Time Control Delay
Echo Level
Echo Level
L in
R in
L out
R out
Tape Echo
Direct Level
Direct Level
Wow/Flutter
Rate 0–127 Speed of wow/flutter (complex variation
in pitch caused by tape wear and rota-
tional irregularity)
Wow/Flutter
Depth 0–127 Depth of wow/flutter
Echo Level # 0–127 Volume of the echo sound
Direct Level # 0–127 Volume of the original sound
Level 0–127 Output level
Parameter Value Description
LoFi Type 1–9 Degrades the sound quality. The sound
quality grows poorer as this value is in-
creased.
Post Filter
Type OFF, LPF,
HPF Type of filter
OFF:
no filter is used
LPF:
cuts the frequency range above
the Cutoff
HPF:
cuts the frequency range below
the Cutoff
Post Filter
Cutoff 200–8000 Hz Center frequency of the filter
W/P Noise
Type WHITE,
PINK Switch between white noise and pink
noise.
W/P Noise
LPF 200–8000 Hz,
BYPASS Center frequency of the low pass filter
applied to the white/pink noise (BY-
PASS: no cut)
W/P Noise
Level # 0–127 Volume of the white/pink noise
Disc Noise
Type LP, EP, SP,
RND Type of record noise
The frequency at which the noise is
heard depends on the selected type.
Disc Noise
LPF 200–8000 Hz,
BYPASS Adjusts the cutoff frequency of the low
pass filter applied to the record noise. If
you don’t want to filter out any high fre-
quencies, set this parameter to BYPASS.
Disc Noise
Level # 0–127 Volume of the record noise
Hum Noise
Type 50 Hz, 60 Hz Frequency of the hum noise
Hum Noise
LPF 200–8000 Hz,
BYPASS Center frequency of the low pass filter
applied to the hum noise (BYPASS: no
cut)
Hum Noise
Level # 0–127 Volume of the hum noise
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Balance # D100:0W–
D0:100W Volume balance between the direct
sound (D) and the effect sound (W)
Level 0–127 Output level
Parameter Value Description
R in
R out
L in
L out
Lo-Fi
Lo-Fi
Noise Gen.
2-Band
EQ
2-Band
EQ
Fantom-X678_r_e.book 286 ページ ２００５年５月１２日 木曜日 午後４時４０分