NOTES:
Configuring Engraving Cutters
Switch the primary power on which is located on
the left rear of the unit.
Turn the Emergency (secondary power) switch
clockwise to power the unit on.
The control panel will power on and display the
model and boot version. Once completed the
display will read “HIT ENTER KEY”.
Press the ENTER key to initialize the unit.
Once the initialization is completed, the carriage
will be located to the View position (Left rear).
Place the adhesive sheet (AS-10) in the lower left
corner of the table and place the material.
Summary of Contents for EGX-400
