NOTES:
Configuring Engraving Cutters
Using the arrow keys on the control panel move
the carriage so that the spindle unit is over the
lower left corner of the material.
Once the spindle is over the lower left corner of
the material, press the XY ORIGIN SET button and
press the ENTER key to set that as your origin
point.
Remove the cutter tool from the cutter knob
(brass knob) and install the cutter knob on the
top of the spindle assembly.
Install the solid collet to the bottom of the spindle
assembly and tighten it with the supplied spanner
wrenches 17mm on the bottom of spindle and
10mm on the collet.
•
NOTE:
Do not use the spanner wrench on the
Top Spindle Nut as you will damage the bearings
if you loosen or tighten it.
Summary of Contents for EGX-400
