Roland DPX-2700A, User Manual

Page: 56 / 59

46
Instruction Format Parameter Range ({ } is default) Explanation
ESC .T [ESC].T<P1>;<P2>; P1: The size of the physical I/O {1024 (byte)} Allocates the 40 KB data buffer to the
Set Each Buffer Size <P3> ;<P4>;<P5>;<P6>: buffer I/O buffer, polygon buffer and
P2: The size of the polygon {6144 (byte)} downloadable character buffer by
buffer defining the parameters.
P3: The size of the {6144 (byte)} A [ESC].T instruction without
downloadable character buffer parameters allocates each buffer size to
P4: Ignored the default value, and then clears data
P5: Ignored in the buffers. If the sum of the four
P6: The size of the pen sort {25672 (byte)} parameters exceeds 40960, the
buffer allocation of the 40 KB data buffer is
readjusted. The maximum vale,
minimum value and default value of
each buffer are shown in the table
below. Ifspecifying a value more than
the maximum, the maximum value is
set. If specifying a value other than 0
and less than the minimum, the
minimum value is set. If 0 is specified,
2 is set to the I/Obuffer, 4 to the
polygon buffer, and 0 to the
downloadable character buffer, and 72
to the pen sort buffer.
ESC .S [ESC].Sn: n : Buffer type 0—6 {0} Outputs the currently set capacity of a
Output Each Buffer User-definable buffer. The each buffer
Size capacity corresponding to the
parameters 0 to 6 are as follows.
0: Whole data buffer capacity
1: Physical I/O buffer capacity
2: Polygon buffer capacity
3: Downloadable character capacity
4, 5: Outputs 0 always
6: Pen sort buffer capacity
Abort Instructions
ESC .J [ESC].J: None Aborts both the currently executed
Abort Device device control instruction and output.
Control Instruction
ESC .K [ESC].K: None After executing only the current
Abort RD-GL II RD-GLII or RD-GLIII instruction,
(RD-GL III) clears the data buffer.
Instruction
ESC .R [ESC].R: None Initializes all settings established by
Initialize Device the device control instructions.
Control Instruction However, each buffer size set by the
[ESC].T instruction is taken over.
Monitor Mode Instructions
ESC .Y ESC .( Ignored.
Plotter ON
ESC .Z ESC .) Ignored.
Plotter OFF
ESC .@ Ignored.
Set Monitor Mode
and Control DTR
ESC Q Ignored.
Set Monitor Mode
Buffer type Min. Max. Default
value value value
I/O buffer 2 40884 1024
Polygon buffer 4 40886 6144
Downloadable 444 40882 6144
character buffer
Pen sort buffer 72 40954 25672