25
Installing the pen (or optional digitizing scope)
Install the pen on an unoccupied pen stock. When installing the optional digitizing scope, remove the pen cap
rubber before installing the device on the pen stock.
When using a digitizing scope
Make sure that the pointer of the
digitizing scope (indicated with
“
”) is located as shown in the
figure. In addition, if the pen is
positioned downward, be sure to
look down the digitizing scope
from the top.
n
Digitizing scope
15 Setting for Each Function
Creating the Plotting on Section Film
When using a section film in plotting, the slightest discrepancy in the angle of the paper setting will result in a
discrepancy between the measured angle and the actual plotting. In order to avoid such a discrepancy, the DPX has
a feature to set a total of four points.
* The optional digitizing scope can be used to set points with greater accuracy.
[Example of setting the points]
It is recommended to set the points shown below (except for the offset point) on the thin lines instead of the thick
lines (which are used to indicate the outer frame) on the section film.
4) Y correction point
1) Offset point
2) Base point
3) X correction point
Press the key once
with the top menu displayed.
Press or to select the number of
the pen stock where the pen (or digitizing scope)
will be installed.
Press the key to confirm the selection,
and the pen (or digitizing scope) is loaded in the
pen carriage.
Summary of Contents for DPX-2700A
Page 1: ...USER S MANUAL DRAFTINGPLOTTER DPX 3700A DPX 2700A ...
Page 10: ...viii MEMO ...
Page 59: ...R8 991012 ...
