RP208CN User’s and Installer’s Manual Page 12
Silencing an alarm in progress
Observe the keypad. If any of the following conditions is evident, an alarm has
occurred:
The ARM LED is flashing
Z1,Z2,Z3… are displayed on the LCD
It's best to enter the premises only after police or a security company has
investigated and you feel confident that the burglar is no longer on your
premises.
Disarming an armed system
Before the Entry expires, enter the four digits of your User Code.
NOTE: If you make a mistake when entering your User Code, the keypad will
produce three short beeps and the LCD keypad will display error. If so, press
ECS and re-enter the Code.
12. Bypassing/ Un-bypassing a Zone
When an intrusion zone is bypassed, the zone will not be armed when arming.
When disarming, all the bypassed zones will be automatically un-bypassed.
There are two methods of Bypassing:
Quick Bypassing:
It’s defaulted that all the zones of RP208CN can be set as
Quick Bypass. Bypass a zone, simply press the corresponding key for or
above 2 seconds. For example, to bypass Zone 3, press digit 3 for 2 seconds,
then By Pass Z3 will be displayed on the LCD, which means Zone 3 has been
bypassed successfully. Use the same way to un-bypass the bypassed zone.
When Zone 3 is un-bypassed, Cancel BP Z3 will be displayed on the LCD.
Code Bypassing:
If RP208CN was programmed as code bypassing, then
press: [*]+[1]+[Disarming Code]+[Zone No] to bypass the zone. Use the same
way to un-bypass the zone.
13. Escape Key [ESC]
Keypad [ESC] is suitable for correction system operation.
14. Emergency Keys
RP208CN Keypad (RP208KCL) provides three emergency keys, which can be
