Commissioning
R&S
®
TS-PSAM
27
User Manual 1142.9878.12 ─ 12
Damaged backplane due to bent pins
Bent pins may result in permanent damage to the backplane.
Check the backplane connector for bent pins!
Any pins that are bent must be straightened!
When module is connected, it must be guided with both hands and carefully pressed
into the backplane connector.
●
Push in the plug-in module using moderate pressure.
●
The rear I/O module R&S TS-PDC must be inserted with extra caution, making cer-
tain the connector is correctly guided into the socket opening in the backplane. It
must not be inserted at an angle or with incorrect alignment, etc. The short circuit
board guides alone do not ensure absolutely reliable guiding.
●
Multiple adjacent R&S TS-PDC modules should be inserted in order “from left to
right” and removed in the opposite order. Because the spaces are so narrow, care
must be taken not to damage any components on the solder side of the module.
●
The module is correctly located when a distinct 'stop' can be felt.
●
Tighten the two retaining screws on the front panel of the module.
Installing the R&S TS-PDC Module
