Commissioning
R&S
®
TS-PSAM
26
User Manual 1142.9878.12 ─ 12
6
Commissioning
6.1
Installing the R&S TS-PSAM Module
To install the plug-in module, proceed as follows:
●
Run down and power off the TSVP
●
Select a suitable front slot (slots 5-14 possible, preferably slot 8)
●
R&S TS-PSAM should be connected to slot 8 and R&S TS-PICT to slot 9 for an in-
circuit test configuration
●
Remove the front panel from the rear side of the TSVP chassis by slackening off
the screws
Damaged backplane due to bent pins
Bent pins may result in permanent damage to the backplane.
Check the backplane connector for bent pins!
Any pins that are bent must be straightened!
When module is connected, it must be guided with both hands and carefully pressed
into the backplane connector.
●
Apply moderate pressure to insert the plug-in module (use locating pin to attach)
●
The plug-in module is correctly located when a distinct 'stop' can be felt
●
Tighten the top and bottom screws on the front panel of the plug-in module
Install the associated R&S TS-PDC rear I/O module as described in Section 6.2.
6.2
Installing the R&S TS-PDC Module
To install the plug-in module, proceed as follows:
●
The R&S TS-PSAM module must have been installed beforehand
●
Select the corresponding rear I/O slot for the R&S TS-PSAM module
●
Remove the corresponding rear panel portion from the R&S CompactTSVP chas-
sis by loosening the two screws
Installing the R&S TS-PDC Module
