Operating Concepts
R&S
®
NRP Series
40
Getting Started 1419.0170.02 ─ 12
If you want to use an android device like a tablet or a smartphone, use the
R&S Power Viewer Mobile. For details, see
Setup
Figure 6-3: Setup with the R&S Power Viewer
1 = Signal source
2 = R&S NRP power sensor
3 = Host interface connector
4 = R&S NRP
‑
ZKU cable
5 = USB connector
6 = Computer with installed R&S Power Viewer
Incorrectly connecting/disconnecting the R&S NRP power sensors can
damage the power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensor as described in
Chapter 4, "Preparing for Use"
Starting a measurement
1. Connect the cables as shown in
For a detailed description, refer to
Chapter 4.6.1.1, "Simple USB Connection"
2. Start the R&S Power Viewer.
3. Execute zeroing:
Note:
Turn off all measurement power signals before zeroing. An active mea-
surement signal during zeroing causes an error.
a) Switch off the measurement signal.
R&S Power Viewer
