Preparing for use
R&S
®
HMP Series
27
Getting Started 1178.6791.02 ─ 03
To switch on the R&S
HMP
The instrument is off but connected to power, see
► Press the [Power] key at the
The R&S
HMP performs a system check, boots the operating system, and
starts the firmware.
It starts up in the operating mode used before the last switch-off.
Note:
At startup, the instrument turns off all signal outputs to protect a con-
nected DUT (load). This function prevents the DUT from being supplied and
even damaged unintentionally caused by the latest instrument settings.
To shut down the R&S
HMP
► Press the [Power] key.
The operating system shuts down.
The R&S
HMP saves all current instrument settings (nominal values) in non-
volatile memory, and restores the settings when you switch it on again.
To disconnect from power
The R&S
HMP is switched off, i.e. the [Power] key is off.
►
NOTICE!
Risk of data loss. If you disconnect the product from power when it
is in the ready state, you can lose settings and data. Shut it down first.
Disconnect the AC power cable from the socket outlet.
Switching on and off