Rohde & Schwarz GB4000V, User Manual

Page: 41 / 70

R&S GB4000V Audio Unit
User Manual 6174.7514.02 - 02 39
3.9.2.2
Setting Up Connection to the Web Server
The section below describes how to set up a connection between the audio unit and
the configuration computer:
1. Start the web browser on the configuration computer and enter the following
addr
ess: “http://<IP-address-of-GB4000V>”.
Note: The IP address can be reset to the default factory setting using the SETUP
button. See chapter
“3.7”
.
2.
The “status” web page of the web interface of the audio unit now appears in the
web browser. The Status page simply shows the non-configurable data of the
audio unit; refer to chapter “3.10”.
3. After successful setup of the connection, the hyperlinks Status, Configuration,
Configuration GB2PP and Configuration VoIP in the top part of the web page
can be used to switch between the web pages of the audio unit.
4.
On “config” page, the general configuration of the R&S GB4000V can be
changed. The meaning of the parameters is explained in chapter “3.9.3”; refer
to “Table 14, Table 15, Table 16”.
5. On the Configuration ACL page, the ACL of the R&S GB4000V can be
configured. The meaning of the parameters is explained in chapter “3.9.3”; refer
to “Table 17”.
6.
On “config-voip” page, the VoIP configuration of the R&S GB4000V can be
configured. The meaning of the parameters is explained in chapter “3.9.3”; refer
to “Table 18”.
7. After a parameter has been changed via the web interface, click at the
“Write
Configuration
” button so that the changes are saved in the non-volatile memory.
Some parameters require a reboot when they are changed. In that case a
restart prompt message is displayed in the web interface. Restart can be
triggered by clicking the Restart GB4000V button. After the restart, the web
browser reconnects automatically to the Status page of the R&S GB4000V.