Rohde & Schwarz GB4000V, User Manual

Page: 45 / 70

R&S GB4000V Audio Unit
User Manual 6174.7514.02 - 02 43
3.10 Device Status
The status of the R&S GB4000V can be evaluated not only using the LEDs on the front
panel of the R&S GB4000V but also using the web interface. For this purpose, a
connection to the web interface must be set up in the way described in chapter
“3.9.2.2”
. The following information can be read out on the Status page of the
R&S GB4000V:
General status
Parameter Description
Status GO: The unit is ready for operation.
NOGO: A system fault has occurred.
Temperature top Temperature on the top side of the R&S GB4000V hardware
Temperature bottom Temperature on the bottom side of the R&S GB4000V hardware
Table 19: Meaning of information of General Status group.
Network
Parameter Description
MAC Address MAC address of the R&S GB4000V. This parameter is set for the R&S GB4000V
during production. The MAC address is used for unambiguous identification.
IP Address Set IP address of the R&S GB4000V.
Subnet Mask Set Subnet mask of the R&S GB4000V. It can be configured via the web interface.
Gateway Set Gateway of the R&S GB4000V. It can be configured via the web interface.
Table 20: Meaning of information of Network group.
Information
Parameter Description
Location Info Set Location info. It can be configured via the web interface.
Installation Info Set Installation info. It can be configured via the web interface.
Table 21: Meaning of information of Information group.
Inventory
The module data of the R&S GB4000V is listed here. This data is used to identify the
various components of the R&S GB4000V and firmware version.