Rohde & Schwarz CMW-KM645, User Manual

Page: 43 / 65

Command Reference
R&S
®
CMW-KM645
43 User Manual 1173.9740.02 ─ 04
Example: See Continuous and AF Measurements
Firmware/Software: V1.0.15.20
Manual operation: See "Repetition" on page 22
CONFigure:FMSTereo:MEAS<i>:SCONdition <StopCondition>
Qualifies whether the measurement is stopped after a failed limit check or continued.
SLFail
means that the measurement is stopped and reaches the
RDY
state as soon
as one of the results exceeds the limits.
Parameters:
<StopCondition> NONE | SLFail
NONE: Continue measurement irrespective of the limit check
SLFail: Stop measurement on limit failure
*RST: NONE
Example: See Specifying Measurement Control Settings
Firmware/Software: V1.0.15.20
Manual operation: See "Stop Condition" on page 23
CONFigure:FMSTereo:MEAS<i>:MOEXception <MeasOnException>
Specifies whether measurement results that the R&S CMW identifies as faulty or inac-
curate are rejected.
Parameters:
<MeasOnException> OFF | ON
ON: Results are never rejected
OFF: Faulty results are rejected
*RST: OFF
Example: See Specifying Measurement Control Settings
Firmware/Software: V1.0.15.20
Manual operation: See "Measure on Exception" on page 23
CONFigure:FMSTereo:MEAS<i>:MEValuation:SCOunt:RFCarrier <StatisticCount>
Specifies the statistic count of the measurement. The statistic count is equal to the
number of measurement intervals per single shot. Use
CONFigure:...:MEAS<i>:...:REPetition SINGleshot | CONTinuous
to
select either single-shot or continuous measurements.
See also: "Statistical Settings" in the R&S CMW user manual, chapter "Remote Con-
trol"
Measurement Control Commands
深圳德标仪器
135-1095-0799