Rohde & Schwarz CMW-B400B, User Manual

Page: 30 / 97

GUI Reference
R&S
®
CMW-B400B/-B405A
30 User Manual 1176.8116.02 ─ 04
This softkey is only visible if the digital audio measurement tab is selected.
The softkey shows the current state of the digital audio measurement. Additional mea-
surement substates may be retrieved via remote control.
Remote command:
INITiate:AUDio:MEAS<i>:DIGital
ABORt:AUDio:MEAS<i>:DIGital
STOP:AUDio:MEAS<i>:DIGital
FETCh:AUDio:MEAS<i>:DIGital:STATe?
FETCh:AUDio:MEAS<i>:DIGital:STATe:ALL?
4.3 Audio Measurement Settings
To access the analog and digital measurement settings, select the "Analog Meas" tab
or the "Digital Meas" tab and press the "Config" hotkey. The tabs are only displayed if
the currently active scenario involves internal audio measurements and generators.
The following sections describe the "Analog Meas" and "Digital Meas" tabs of the con-
figuration dialog box.
Fig. 4-4: Configuration dialog box for measurements and generators
● General Settings (Analog) .......................................................................................30
● General Settings (Digital) ........................................................................................33
● Single Tone Settings ...............................................................................................34
● Multitone Settings ....................................................................................................37
● FFT Noise Settings ................................................................................................. 38
4.3.1 General Settings (Analog)
The settings at the top of the "Analog Meas" tab apply to all analog measurements.
Audio Measurement Settings
深圳德标仪器
135-1095-0799