Rohde & Schwarz CMW-B400B, User Manual

Page: 33 / 97

GUI Reference
R&S
®
CMW-B400B/-B405A
33 User Manual 1176.8116.02 ─ 04
●
Auto ranging:
If auto ranging is enabled, the maximum expected AF input level is set automati-
cally according to the average level of the measured AF signal plus an appropriate
overload margin.
●
Manual configuration:
If auto ranging is disabled, the manually configured "Maximum Level" is applied.
To optimize the "Maximum Level" setting, start with a very low value. Then
increase it, until the error message "Input Overdriven" disappears.
Remote command:
CONFigure:AUDio:MEAS<i>:ANALog:ARANging
CONFigure:AUDio:MEAS<i>:ANALog:MLEVel
4.3.2 General Settings (Digital)
The settings at the top of the "Digital Meas" tab apply to all digital measurements.
Fig. 4-6: General digital measurement settings
Coupled with ................................................................................................................. 33
Routing ..........................................................................................................................33
Repetition ...................................................................................................................... 34
Stop Condition ...............................................................................................................34
Statistic Counter ............................................................................................................34
Coupled with
Displays the coupling of the measurement to a generator. The measurement can be
used standalone ("Off") or it can be coupled to an analog or digital generator.
The coupling is configured within the generator settings, see "Analyzer Coupling"
on page 41.
Remote command:
n/a
Routing
Displays the input connector for the measured digital audio signal (SPDIF IN) and the
evaluated channel (-L or -R). This setting is not configurable.
Remote command:
n/a
Audio Measurement Settings
深圳德标仪器
135-1095-0799