R&S FSH
Getting Started
Using a Power Sensor
Quick Start Guide 1309.6269.12 - 09
64
2.3 Using a Power Sensor
For highly accurate power measurements, you can connect one of the power sensors
that are supported by the R&S FSH.
The power sensors R&S FSH-Z1 and -Z18 are especially designed for use with the
R&S FSH.
You can connect the power sensors available for the R&S FSH to the RS-232-C
interface on the top face of the R&S FSH. This connector allows you to control the
power sensor and supplies it with power.
It is also possible to use one of the R&S NRP power sensors. When you use one of
these, connect it to the USB interface on the right side of the R&S FSH.
Note that only R&S FSH models with a 20 MHz bandwidth (serial numbers 105000 and
higher) have an USB port.
