R&S FSH
Putting into Operation
Configuring the R&S FSH
Quick Start Guide 1309.6269.12 - 09
38
When this feature is on, and a sufficient connection to GPS satellites is established,
the R&S FSH displays the GPS coordinates in a blue bar below the hardware
information.
When the connection to a satellite is lost, the bar turns red and the GPS coordinates
are shown in brackets. However, the R&S FSH still shows the last valid position.
The state of the satellite lock is shown in the title bar.
in the title bar indicates that the GPS receiver is enabled and that there is a fix
connection with enough satellites for the GPS receiver to provide the coordinates. The
GPS information bar is blue.
in the title bar indicates that the GPS receiver is enabled but that there is no fix
connection to a satellite. The GPS information bar is red. The coordinates are not
updated.
in the title bar indicates that the GPS receiver is enabled, but that the receiver is
not connected, not connected properly or defective. The GPS information bar is red.
The coordinates are not updated.
The title bar shows no symbol, if the GPS receiver is not enabled.
If the GPS receiver is connected and enabled when you boot the R&S FSH, it asks
whether to restore the GPS coordinates that were active just before it was shut down.
Selecting the coordinate format
► In the "Instrument Setup" dialog box, select the "Coordinate Format" item.
► Press the ENTER key.
A dropdown menu to select the coordinate format opens.
► Select the format you are most comfortable with from the dropdown menu.
► Confirm the selection with the ENTER key.
