Appendix
R&S
®
TS-PCA3
87
User Manual 1152.3908.12 ─ 19
A.1.3.2
Version-dependent effects
R&S TS-PDC
Can only be fitted to rear slots of modules designed
for the use of a R&S TS-PDC.
The old R&S TS-PDC V1.0 (serial No.100001 to
100192) must be brought up to the level of V1.1
manually to work with the new backplane V4.x by
rewiring to V1.1 state, since the +5-V power supply
on the back of the backplane was moved to another
pin.
CAN bus is disabled in backplane V4.x, although
this can only affect a special application.
R&S TS-PMB V2.x (has only one cPCI connector,
X20), serial No. to 100182
Can be connected up to backplane V3.x in slots 5 to
16.
In V4.0 can only be plugged directly into slots 15
and 16. Modules must be upgraded to revision index
2.14 in order to be operated in slots 5 to 14, and a
R&S TS-PRIO module must be connected on the
rear side.
Only V3.x is delivered in new deliveries.
R&S TS-PMB V3.x (has 2 cPCI connector), serial
No. starting at 100183
Can be connected to slots 5 through 16 in all ver-
sions, and in slots 3 and 4 as well for V4.x (higher
pin configurations possible with ICT).
Can also be used in slots 3 and 4 in backplane V4.x;
(caution: danger of slot 3 touching the shield springs
of the embedded CPU with the module circuit board
in slot 3)
R&S TS-PSM1
Can be used in backplane V1.x to V3.x on slots 3 to
16.
Starting with V4.x, can only be used in slots 15 and
16.
Because external signals can be supplied from the
rear, we recommend operating R&S TS-PSM1 in
slot 16 or possibly in slot 15.
R&S TS-PIO1
Can be used in backplane V1.x to V3.x on slots 5 to
16. Starting with V2.1,
±
12 V is no longer available.
Starting with V4.x, can only be used in slots 15 and
16. Starting with serial No. 100160 can also be used
in slots 5 to 14 if R&S TS-PRIO is connected to the
rear side; provided no
±
12 V is present.
PXI third-party modules
In backplane version V2.0 there are power supply
voltages on some local bus leads. There is a poten-
tial danger of destroying the third-party module here.
±
12 V and some +5-V pins have been removed on
local bus.
Can be used starting with V4.0 on all PXI slots 5
through 14 without any restrictions; no power supply
voltages in the X20 connector.
R&S TS-PSC0
Can be used starting with V2.0; must be connected
in the rear to slot 1; slot in front must remain free, so
no controller must be fitted in the front slots.
R&S TS-PCA3 Backplane Versions