Rogerblack GM-41002, Instructions And Parts Manual

Page: 34 / 40

COMPUTER INSTRUCTIONS
32
HOW TO MAINTAIN THEGM-41002 TREADMILL
HOW TO MAINTAIN THE
GM-41002
TREADMILL :
Proper maintenance is very important to ensure your treadmill is always in top working condition. Improper maintenance
could cause damage or shorten the life of your treadmill and exceed the LIMITED WARRANTY coverage.
•
Important : Never use abrasives or solvents to clean the treadmill. To prevent damage to the computer, keep
liquids away and keep it out of direct sunlight.
•
Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.
BELT ADJUSTMENT :
Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has been
adjusted properly at the factory. However transportation, uneven flooring or other unpredicted reasons could cause the belt to
shift off center resulting in the belt rubbing with the plastic side rail or end caps and possibly causing damage. To adjust the
belt back to it’s proper position please follow the directions below:
•
Walking belt has shifted to the left : First unplug the power cord from themains. Using the hex key provided, turn
the left rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the mains and
run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat
the above procedure until the walking belt is centered. It may be necessary to set walking belt tension once you
have completed this procedure if the belt feels like it is slipping while walking. Refer below to the "Walking belt
slipping" instructions.
•
Walking belt has shifted to the right: First unplug the power cord from the mains. Using the hex key provided,
turn the right rear roller adjustment bolt 1/4 turn in the clockwise direction. Plug the power cord back into the
mainsand run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the
center. Repeat the above procedure until the walking belt is centered. It may be necessary to set walking belt
tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to the
"Walking belt slipping" instructions.
•
Walking belt is slipping : First unplug the power cord from the mains. Using the hex key provided, turn both the
left and right rear roller adjustment bolts the same distance, usually a 1/4 turn in the clockwise direction. Plug the
power cord back into the mainsand run the treadmill at 2.5 mph. You should now walk on the belt to determine if the
belt is still slipping. Repeat the above procedure until the walking belt is not slipping. The tension should be just
tight enough not to slip.
1. WARNING! Do not over tighten rollers! This will cause premature roller bearing failure!