Roger SL2000B, Manual

Page: 2 / 13

Electronic Code Locks SL2000B v1.4 and SL200S1K v1.3 EN Rev.C.doc 2011-11-16
Strona 2 z 13
Features
 Bell output to indicate Door Bell and Door Alarm
 Bistable/Switch output to control door locking device
 DC input for detection of door status
 DR input to unlock the door from the external button
 INSTALLER code for programming
 MASTER code switch between armed and disarmed modes
 55 USER codes for door unlocking
 Programmable length of codes
 User indexing for easy administration of the codes
 Nonvolatile memory
 Three LEDs and buzzer
 Tamper
 12VDC supply
 CE
Introduction
The SL2000 electronic code lock is dedicated to operate as a stand-alone door access
control unit. It is equipped with one relay output, two transistor outputs and three inputs.
All codes and parameters programmed to device are stored in nonvolatile memory.
SL2000S1K is located in metal enclosure and can operate in outdoor locations.
Functional Description
Output
SL2000 has one relay output and two transistor outputs (Bistable/Switch i Bell).
Relay output
The REL output offers one switched NO/NC contact rated 1.5A/30V AC/DC. This output is
activated each time a user code sequence is entered (User code 01..55). Activation takes
place after a
C1C2 delay and lasts for the time specified by the C3C4 parameter. Each
time the RELAY switch of SL2000 lock is activated the yellow led ENTRANCE lights up.
By using the Main code it is possible to temporary disable/enable activity of all user
codes (Disable USER Codes When in Armed Mode).
Open collector outputs
The Bistable (Switch in SL2000B) and BELL outputs of SL2000 lock are an open collector
transistor type. Some care must be taken in order to protect them from damage. When
transistor output is switched off it remains in high impedance state, when switched on it
shorts connected to it potential with supply minus. The maximum current must not
exceed 1A and maximum voltage must not exceed 15VDC.
Note: The C1,C2…C10 parameters which appear in this manual refer to the configuration
parameters programmed to the SL2000 during
Memory Reset procedure (for details see
section: Configuring the SL2000 later in this document).