Roger SL2000B, Manual

Page: 6 / 13

Electronic Code Locks SL2000B v1.4 and SL200S1K v1.3 EN Rev.C.doc 2011-11-16
Strona 6 z 13
Configuring the SL2000 — Memory Reset
In order to configure the SL2000 you must perform the Memory Reset procedure and
then enroll sequentially 10 digits (C1,C2..C10) which will configure the unit for the
individual installation. After the
Memory Reset the entire code lock memory is erased
(including all codes) and initialized with default (factory) settings.
In order to perform Memory Reset do the following steps:
 Turn off the power supply
 Put the jumper on JP1 contacts (PZ3 in SL2000B)
 Turn on the power supply
 Wait till the moment when SL2000 will generate three series of two beeps (** **
**) - this signal indicates that unit has erased memory and restored default
configuration parameters
 Remove jumper from JP1 contacts (PZ3 in SL2000B)
 Enter sequentially ten digits from C1 to C10
 Once the last digit ( C10 ) is entered the code lock generates three series of two
beeps (** ** **) and automatically switches to normal work (it enters Armed
mode).
Meaning of the configuration parameters: C1-C10
C1C2:
Specifies the time delay from a moment when USER code is entered till moment
when Door Lock output will be triggered. It can be programmed from 00 to 99s (default:
04).
C3C4: Specifies the time for which Door Lock output will be activated. It can be
programmed from 02 to 99s (default: 04).
C5C6: Specifies the time within door must be closed otherwise Door Alarm will occur.
The C5C6 time is started from the moment when C4C4 time has passed by. It can be
programmed from 00 to 99s, the 00 value sets unlimited time for door closing (default:
09).
C7: Enables or disables of reprogramming of the MASTER and INSTALLER codes, enter 0-
3 (default: 0).
C7
Reprogramming of the MASTER
code Reprogramming of the INSTALLER
code
0 Enabled Enabled
1 Disabled Enabled
2 Enabled Disabled
3 Disabled Disabled
Note: If reprogramming of a given code is disabled the SL2000 allows you for a single
attempt only to program of the given code. Once the code is programmed, you will not
be able to change it unless the
Memory Reset is carried out. Use this function to disable
the end user to change your MASTER and INSTALLER code.