Roger Technology BRUSHLESS B70/2DC, Instruction And Warnings For The Installer, Page: 20 / 116

20
1
Introduction to the instructions and warnings
This manual is only intended for personnel
qualified to perform the installation.
No information contained in this document may be
considered of interest to the end user.
This manual refers to control panel B70/2DC for
automations comprising 1 or 2 ROGER brushless
motors and should not be used for other motors.
ELECTROCUTION
HAZARD
Read the
instructions
carefully before
starting the
installation.
To avoid the risk of electrocution and physical injury
always cut the power before intervening on the
device.The installation must only be carried out by
qualified service personnel according to applicable
regulations.Make the connections to the currents
and voltages required with the appropriate cables;
observe the product’s technical characteristics.
Check the conformity of the earth system and the
continuity between the earth on the motor side and
the control unit’s terminal block.
The same type of motors must be used for both
wings.The slowdowns can be set independently:
ensure that they are appropriate for the type of
installation, in order to prevent the wings from
overlapping.
WARNINGS
EN
TABLE OF CONTENTS
pag.
1 Introduction to the instructions and
warnings
20
2 Product technical characteristics 20
3 Product description 21
3.1 Description of connections and fuses 21
3.1.1 Motors connection 22
3.2
Standard photocells configuration 22
3.3 Standard safety edges configuration 22
3.4 Radio receiver coupling 22
3.5 Display operation modes 22
3.5.1
Commands and safety protections
status mode
23
3.5.2 Parameters mode 23
3.5.2.1 Changing a parameter 24
3.5.2.2 Restoring standard factory param -
eters
25
3.5.2.3
Simplified/extended parameters
mode change
25
3.5.3 Standby mode 25
3.5.4 TEST mode 25
4 Installation 26
4.1 Stroke programming sequence 26
4.2 PHOTOCELL TEST mode 27
4.3 Error reporting 27
4.4 Position recovery mode 27
4.5 Battery operation mode 28
4.6
Extended operation mode 28
5 Inspection 37
6 Maintenance 37
7 Disposal 37
2
Technical product characteristics B70/2DC
SUPPLY VOLTAGE 230Vac ± 10% 50Hz
MAXIMUM POWER CONSUMPTION 350W
CONNECTIBLE MOTORS 2
POWER SUPPLY MOTORS 24Vac with self-protected invert
MOTOR TYPES brushless sinusoidal (ROGER BRUSHLESS)
MOTOR CONTROL TYPE Field oriented control (FOC), sensorless
RATED POWER FOR MOTOR 40W
MAXIMUM POWER FOR MOTOR 110W
MAXIMUM POWER FLASHING 25W (24Vdc)
INTERMITTENT FLASHING 50%
MAXIMUM POWER COURTESY LIGHT 100W 230Vac - 40W 24Vac/dc (pure contact)
GATE OPEN LIGHT POWER 3W (24VDC)
ELECTRIC LOCK POWER 15W (12VDC)
ACCESSORIES OUTPUT POWER 10W (24VDC)
OPERATING TEMPERATURE -20°C … +60°C
DEGREE OF PROTECTION IP54
PRODUCT DIMENSIONS Dimension in mm. 330 x 230 x 115 Weight: 3,9Kg