EN
53
10
Travel acquisition
*SVXLIW]WXIQXSJYRGXMSRGSVVIGXP]XLIHSSVXVEZIPQYWXFIEGUYMVIHF]XLIGSRXVSP
&IJSVIWXEVXMRK
1. Check the number of motors installed from the parameter
. This parameter is set for two motors by default
.
2. Check that the operator present function is not enabled (
$
).
3. Press
TEST
(see TEST mode in chapter 7) and check the command signal and safety device states. If any safety
HIZMGIWEVIRSXMRWXEPPIHNYQTIVXLIVIPEXMZIGSRXEGXSVHMWEFPIXLIHIZMGIJVSQXLIVIPEXMZITEVEQIXIV
(
).
4. Check that the limit switches are set correctly. Check the door closed limit switch in particular.
5. Check that the motors are connected correctly.Both motors must rotate in the same direction.
ACQUISITION PROCEDURE:
PROG
TEST
AP P-
x4 s
PROG
Yes
No
See safety input (Chap. 13) and
Alarm and fault (Chap. 14)
TEST
TEST
00
23
AU to
AU to
CL OS
Yes
OPENING
OPEN
CLOSURE
CLOSED
CLOSURE
CLOSED
• Open the door into an intermediate position.
• Press and hold
PROG
for 4 seconds.
$3 3
is shown on the display.
• Press
PROG
again. The acquisition procedure now starts. The message
&/26
appears on the display.
• The door starts closing at low speed
3RGIXLIHSSVGPSWIHWXSTMWVIEGLIHXLIHSSVWXEVXWERSTIRMRKQERSIYZVI
at low speed.
$XWR
is shown on the display.
•
8LIHSSVWXSTWFVMIƽ][LIRMXVIEGLIWXLIHSSVSTIRWXST
.
$XWR
ƽEWLIWSRXLIHMWTPE]
.
• The door closes until it reaches the door closed stop.
-JXLIEGUYMWMXMSRTVSGIHYVIMWGSQTPIXIHWYGGIWWJYPP]XLIHMWTPE]IRXIVWXLIGSQQERHERHWEJIX]HIZMGIWXEXIHMWTPE]
mode.
-JXLIJSPPS[MRKIVVSVQIWWEKIWEVIWLS[RSRXLIHMWTPE]VITIEXXLIEGUYMWMXMSRTVSGIHYVI
•
$33(
EGUYMWMXMSRIVVSV
•
$33/
XVEZIPPIRKXLIVVSV
•
$33&
HSSVGPSWIHPMQMXW[MXGLIVVSV'LIGOXLEXXLIHSSVGPSWIHPMQMXW[MXGLMWWIXGSVVIGXP]WIIGLETXIV
Yes
Yes
Summary of Contents for B70/2B
Page 2: ...2 ...
