Rodgers Trillium T797, Owner'S Manual

Page: 86 / 100

75
MIDI Connections
There are multiple MIDI jacks on the T797, labeled SEQ IN / OUT and MIDI IN/OUT/THRU .
Always connect a sequencer or sequencer/sound module combination (such as the Rodgers PR-
300S) to the
SEQ IN/OUT ports on the organ. The sequencer must not be in Soft Thru
mode. Any other MIDI instruments or keyboards should use the ports labeled MIDI .
MIDI Save
Many changes to MIDI settings are temporary and are lost when the organ is turned off.
However, the MIDI Save procedure can store many of these new settings as the default, so that
the change is retained when the organ is powered off.
Please note that there are a few MIDI settings which cannot be changed and saved using the
MIDI Save procedure.
Saving MIDI Control Settings
To perform the MIDI Save procedure:
1. While in any MIDI menu, make the desired changes.
2. Press and hold the SET piston, then press and hold General Cancel (‘ 0 ’).
Continue to hold both pistons for approximately five seconds, until the following
screen is displayed:
M I D I C o n t r o l
S e t t i n g s S a v e d
10. Release both pistons. The changes have been saved as the default.
Saving a Combination Memory to a Sequencer
The contents of any combination memory may be saved to a MIDI sequencer and later reloaded
into the organ. This allows storage of registrations in an external device.
Saving a Combination Memory
To save a combination memory to a sequencer:
1. Make sure the sequencer is connected correctly to the SEQ IN and SEQ OUT
jacks.