Rodgers Trillium T797, Owner'S Manual

Page: 36 / 100

25
Restoring Factory Crescendo Setting
1. Press and hold the GT/PED UNENCL piston for approximately five seconds.
The Console Display reads CRESCENDO LOCKED or CRESCENDO
UNLOCKED.
2. While holding GT/PED UNENCL , press and hold SET for an additional five
seconds. The Console Display reads CRESCENDO FACTORY DEFAULT.
3. Release both pistons.
TUTTI Settings
The flexible computer-based control system of the T797 allows you to easily view and change
the contents of
Tutti , if desired. In addition, you can always restore the Tutti contents to factory
defaults.
Viewing Tutti Setting
Normally, stops stored in Tutti do not light when the control is activated.
To cause all stored stops and couplers to light so that Tutti can be viewed:
1. Press and hold the TUTTI piston.
2. While holding the piston, press SET . The stops and couplers contained in the
Tutti will light.
3. Press General Cancel (‘ 0 ’) to return to the Transposer menu.
Unlocking or Locking Tutti
The Tutti controls are usually locked to prevent accidental changes. Before they can be
programmed, they must be unlocked. After they have been changed, it’s also a good idea to
lock them again.
To unlock or lock Tutti:
1. Press and hold the TUTTI piston for approximately five seconds;
TUTTI
LOCKED or TUTTI UNLOCKED appears in the Console Display.
2. If desired setting (Unlocked/Locked) appears in the display, release the Tutti
piston. Otherwise, go to step 3.
3. While continuing to hold the Tutti piston, rotate the Alpha dial in either direction
to change the setting.
4. Release the Tutti piston.