User guide
Doortello Business
Issue 1.00
Page 16
Tones during programmation
During programmation you will hear the following tones:
Answer tone
:
1 short tone. Is sent when the call is answered and the unit ready
to accept more commands.
OK tone
:
3 short tones. The data input or command is correct.
NOOK tone
:
6 short tones. The data input or command is not correct, last data
input is lost.
Error tone
:
9 short tones. There was an error on the device memory. Data could
not be stored and are lost.
Password (default
)
OK tone
Now the programming mode is activated. The red LED (if installed) will go on and
the green LED (if installed) off. The green LED (if installed) will flash with every
positive detection of a DTMF digit.
To terminate the programming mode dial
.
Please note!
If you terminate the call hanging up the handset without dialling the digit
all the data inserted up to this time will be lost!
Please note!
It may be that the programming mode activation using a password has been
deactivated with a previous programmation. Is this case the programming
mode is activated just after the input of the
digits.
Please note!
The password could has been changed. If you hear a
NOOK tone
you have a
wrong password.
Please note!
As soon as the device will answer the call a maximum connection timer will
start. This is set as default at a value of 60 seconds. At the end of this time
the unit will disconnect the line. All data inserted until this time will be lost.
We suggest you to change this time if you plan an extensive programmation.
Please note!
When you terminate the programming mode with the digit
all
programmed data will be transferred from the RAM to the flash memory. This
will take about 30 seconds. During this time the device is not available.
