Rockwell Automation Publication SYSLIB-RM056B-EN-P - February 2017
55
PowerFlex 7000 Drive (P_PF7000)
Enable navigation
to run reverse
permissive object
Check if a permissive object is
connected to Inp_RevPermOK. The
Permissive indicator becomes a
button that opens the Reverse
Permissive faceplate.
IMPORTANT:
The name of the
Reverse Permissive object in the
controller must be this object's name
with the suffix ‘_RevPerm’. For
example, if your P_PF7000 object has
the name ’Drive123’, then its Reverse
Permissive object must be named
‘Drive123_RevPerm’.
Engineering
Configuration
(Code E)
Cfg_HasRevPermObj
Enable navigation
to interlock object
Check if an interlock object is
connected to Inp_IntlkOK. The
Interlock indicator becomes a button
that opens the interlock faceplate.
IMPORTANT:
The name of the
Interlock object in the controller must
be this object's name with the suffix
‘_Intlk’. For example, if your
P_PF7000 object has the name
’Drive123’, then its Interlock object
must be named ‘Drive123_Intlk’.
Cfg_HasIntlkObj
Enable navigation
to restart inhibit
object
Check if a restart inhibit object is
connected. The button that opens the
Restart Inhibit faceplate appears.
IMPORTANT:
The name of the
Restart Inhibit object in the controller
must be this object's name with the
suffix ‘_ResInh’. For example, if your
P_PF7000 object has the name
’Drive123’, then its Restart Inhibit
object must be named
‘Drive123_ResInh’.
Cfg_HasResInhObj
Enable navigation
to runtime object
Check if a runtime object is
connected. The button that opens the
Runtime faceplate appears.
IMPORTANT:
The name of the
Runtime object in the controller must
be this object's name with the suffix
‘_RunTime’. For example, if your
P_PF7000 object has the name
‘Drive123’, then its Runtime object
must be named ‘Drive123_RunTime’.
Cfg_HasRunTimeObj
Stop Drive:
On I/O Fault
When checked, if an I/O Fault
condition is detected, the instruction
attempts to stop the motor (sheds),
an I/O Fault Status and Alarm are
asserted, and the shed condition is
latched until reset.
When you clear the box, if an I/O
Fault condition is detected, the
instruction asserts the I/O Fault
Status and Alarm but does not
attempt to stop the drive and does
not latch the shed condition.
Cfg_ShedOnIOFault
Table 18 - Engineering Tab Page 3 Description
Function
Action
Security
Configuration Parameters
