Industrial 18.1" Flat Panel Monitor
41
Publication 6185-UM001B-EN-P
The RAC6185 18.1" Flat Panel Monitor is configured at the factory, but
typically requires initial adjustments to ensure the best screen image.
Rockwell Automation provides the Flat Panel Monitor Adjustment
Utility with each flat panel monitor to assist you in adjusting the monitor
settings.
Workstation Setup
There are three important aspects of your workstation setup that affect
the screen image of the RAC6185 18.1" Flat Panel Monitor:
•
Monitor type
•
Video resolution
•
Video refresh rate
You need to verify that your workstation is using the appropriate settings
for these before you begin to adjust the monitor itself.
Note:
Verify and change these settings for your workstation using
the Windows Control Panel. Select the Start button and
select Settings to access Control Panel. In Control Panel,
select Display to access monitor settings. The options on
the Control Panel screens may vary depending on your
video driver.
Monitor Type
If you are using Windows 95 or Windows 98 and your video card
supports it, you should enable your workstation to detect Plug & Play
monitors and select Plug and Play as the monitor type. To access these
settings from Control Panel, select the Settings tab and select either
Change Display Type or Advanced Properties. Windows will detect the
flat panel monitor and configure your workstation with the appropriate
settings.
If your video card does not support Plug and Play, or if you are using
Windows NT, you should select “Super VGA 1280x1024” from the list
of standard monitor types.
Note:
This monitor has a flat panel display, but it uses the
workstation’s analog VGA interface. Because of this, some
setup screens may indicate that the monitor is operating as a
CRT (analog) device, rather than a flat panel (digital)
device.
Initial Video Setup
(All Models)
Summary of Contents for 6185-D
Page 63: ......
