26
Industrial 18.1" Flat Panel Monitor
Publication 6185-UM001B-EN-P
To attach the monitor to the arm (benchtop or wall arm mount):
1.
Place the monitor over the arm. Insert the four M4 x 0.7 screws
through the arm brackets and into the monitor.
Note:
The horizontal arm has a 75 to 100 mm adapter plate. This
adapter plate is already installed.
Figure 21
Attaching the Monitor to the Arm
2.
Tighten the screws.
To mount the monitor (yoke mount):
The Versa mount unit can be mounted using a yoke bracket assembly
that allows the operator to tilt or swivel the monitor for ideal viewing.
You can mount the yoke directly to the horizontal or vertical surface,
allowing the unit to tilt, or you can mount the yoke on a base bracket that
allows the unit to swivel (horizontal surface only).
1.
Mark the location at which you need to install the yoke. Refer to the
figures on Page 23.
2.
Drill holes for mounting the yoke or the swivel-base mounting
bracket.
3.
Insert four screws through the yoke or the swivel-base mounting
bracket and secure it to the mounting surface. Tighten the screws.
Summary of Contents for 6185-D
Page 63: ......
