finishing.
Limitations in dimensions:
None
Maximum speed:
3000 rpm
The speed can be freely changed during the cut. A stop can be made at any time by pressing
the STOP button.
There are three possible variants:
1.
ZP = 0 and XP = 0 so there are no endpoints at all specified, in which case the movement
after the START signal goes to X 0,00 after a safety query and then in the -Z direction until the
STOP key is pressed. START-Stop operation is possible while the vehicle is in motion. The move
-
ment is aborted only when the STOP button is pressed, after which X and Z are reset to the stop
position.
2.
ZP <> 0 XP = 0, therefore only one end position for Z is specified, no depth. Here the
movement goes directly after the START signal WITHOUT safety query to X 0.00 and then in
-Z direction to the end point Z P. Then a reset to X 0.2 and back to Z 0.00 takes place, then the
position for X and Z changes to the hold position.
3.
ZP < 0 and XP < 0, so the values for length and depth are given here. the cutting is fully
automatic in several passes. after the START signal, the controller first displays all the data for
the individual passes in an overview and then starts again after a new start command. Here you
can also abort by pressing the STOP key.
63
Summary of Contents for ELS 4 Basic
