09
2. LED Indicator and Buzzer:
The LED ring indicates the working status of the Launch controller.
The buzzer will alarm three times, which indicates a low battery and needs to be
recharged.
3. Binding the Receiver:
There are the steps to make the launch controller enter binding status;
i. Power on the Launch controller and wait for its system to load completely. The
LED ring will be solid blue if done correctly.
ii. Press the “
Bind
” button on the back of the Launch controller to enter binding
status. The LED ring will be red and flash quickly.
iii.
The LED ring will change to solid blue 5 seconds later when the Launch
controller exits binding status. If not bind successfully, repeat the process
above.
4. Switching Protocol:
Note:
Switching internal protocol is only available for the Frsky version Launch
controller. Express LRS version can only switch to the external TX module.
The Frsky version could suppo 4 different internal protocols, including Frsky D16
FCC, Frsky D16 LBT, Frsky D8, and Futaba S-FHSS, it also supports. The protocol is
indicated by the flashing times of the LED when power is on, before the buzzer
alarms.
Stage 1 Drone Kit Instruction Manual
