RocHobby DPROC001RS, Instruction Manual

Page: 6 / 76

RADIO SYSTEM INSTRUCTION MANUAL
Warranty
The ROCHOBBY 4 channel radio system is guaranteed to be free from defects in materials and workmanship within 30 days
of the purchase of the product. If the product has been mishandled, abused, used incorrectly or used for an application other
than its intended purpose- ROCHOBBY is not liable for any loss or damage, whether direct or indirect, incidental or conse-
quential, or from any special situatuon, arising from the use, misuse, or abuse of this product.
3. Hand Grip: For holding the transmitter.
Steering Wheel: Controls the steering function of the
model.
1.
Throttle Trigger: Controls forward / reverse / brake
motion
(
designed to be operated with index finger
)
.
2.
Antenna:Transmits signal to the receiver located in the
vehicle.
4.
Battery compartment: Houses [4] AA batteries 9.
10. Channel 3 key.
11. LED.
Channel 4 key. 15.
7. CH3-EPA+/-
8. CH4-EPA+/-
12. Reverse:
1
：
Turn and hold the steering wheel to the left or right
while simultaneously pressing the REV button. An
audible note is emitted and the steering channel will be
reversed.
2
：
Push or pull the throttle trigger to its maximum
position while simultaneously pressing the REV button.
An audible note is emitted and the throttle channel will
be reversed.
3
：
Press CH3 and REV simultaneously. An audible
note is emitted and CH3 will be reversed.
13. ST DR/ST TRIM: Please turn the wheel to left or right
with Max angle, and press ST-TRIM+ or ST-TRIM-,
then adjust the angle of ST.
14. TH DR/ TH TRIM: Please pull or push the throttle to its
maximum position, then press the TH-TRIM+ or
TH-TRIM - button to adjust the maximum output of the
throttle channel.
When adjusting the trim, the transmitter will emit an
audible note for every click of trim. When the trim has
been centered, the transmitter will emit two audible
notes.
When adjusting the dual rates, an audible note will be
emitted with every click of the dual rate. Two notes
signify the dual rate is at its maximum or minimum.
6. Handle release latch.
Power switch:Turns the transmitter ON / OFF. 5.
Function operation introduction
05
13
14
15
EN